Before You Begin
Before you begin verify that the display window on your unit is replaceable.
- Units with field-replaceable windows have the MODIS™ logo located on the display window in the upper left corner
- Units with non field-replaceable windows have the Snap-on® logo located on the unit in the upper left corner above the window
Requirements
You will need the following:
- Display Window Kit (EAK0253L63A)
- Large flat-blade screwdriver
- Small flat-blade screwdriver
Removing the Display Window
To remove the old display window:
- Power off your MODIS unit.
- On the right side of the display window, insert the flat-blade of the large screwdriver in the notch
- Carefully twist the screwdriver, compressing the spring retainers on the left side of the window and exposing upper and lower retaining tabs on the right side of the window
IMPORTANT: Do not use the large screwdriver in the notch to pry out the display window because you may damage your unit
- With the large screwdriver still in position, insert a small screwdriver into the gap next to one of the exposed retaining tabs and lift the tab out of the tab slot
- Repeat Step 4 to lift the remaining tab from the tab slot
- Remove the display window from the casing and discard
Installing the Display Window
To install the new display window:
- Remove the protective plastic film from the back of the new display window
- Insert the retaining tabs on the left side of the new display window into the slots against the spring retainers The display window will be partially seated
- On the right side of the display window, insert the flat-blade of the large screwdriver in the notch on the window