< Back to Results

Low Amp Probe (EETA308D) Battery Replacement

Applies To: MODIS Edge, MODIS Ultra, MODIS™, TRITON-D8, Vantage PRO™, Vantage Ultra™, VERDICT™, VERUS Pro, VERUS™, VERUS™ Wireless

How to access and change the battery in your Low Amp Probe


EETA308D Low Amp Probe Battery Replacement

The RED LED flashes when the minimum operating voltage is approached, indicating that the battery needs to be replaced. When replacing the battery, use the 9-volt alkaline type only. Using any other type of battery in the Snap-on Low Amp Current Probe will invalidate your warranty.


To replace the battery:

  1. Unclamp the probe from the conductor.
  2. Using the On/Off and Range Selector switch, turn the Low Amp probe off.
  3. Disconnect the output leads from external equipment.
  4. Loosen the rear captive screw that secures the front battery cover.
  5. Lift the cover through 30° and pull it clear of the probe body. The battery is then accessible.
  6. Remove the old 9-volt alkaline battery and insert the new 9-volt alkaline battery.
  7. Replace the battery cover and re-tighten the battery cover captive screw. Be careful not to over tighten it.

Last Updated: April 29, 2020

Got Questions?


Contact our Customer Care Department:

Email: techsales.uk@snapon.com

Tel: (01553) 692422

Mon-Fri 8.45am-5pm


For Snap-on Tools or to contact your local dealer, call (01536) 413800

E-mail kettcustserv@snapon.com


Software Subscription enquiries:

(01536) 413825 and choose option one

E-mail kettsubscriptions@snapon.com

Mon-Fri 8.30am-5pm


Snap-on is a trademark of Snap-on Incorporated.

All other marks are trademarks of their respective holders.

© 2020 Snap-on Incorporated. All Rights Reserved.

Got Questions?

Contact our Customer Care Department

Email: techsales.uk@snapon.com

Tel: (01553) 692422


For Snap-on Tools

or to contact your local dealer

call (01536) 413800

E-mail kettcustserv@snapon.com

We welcome your feedback on our website.


Enter your name:



Please rate your experience in the following:
(1 being an unpleasant experience and 10 being exceptional)


 1  2  3  4  5  6  7  8  9  10


 1  2  3  4  5  6  7  8  9  10


Suggested improvements:

Can we contact you by e-mail to discuss your feedack further?


If you would like to receive e-mails from Snap-on about product releases, developments and promotions, please click the box below.